How to clean a Hystar Mouse Pad

Cleaning your Hystar mousepad is a simple process that can help extend its lifespan and keep it looking fresh and new. Here's a step-by-step guide on how to do it.

Step 1: Gather your supplies. To clean a water-resistant mousepad, you'll need a mild soap or detergent, a soft cloth or sponge, some lukewarm water, and a basin to place the mouse pad into such as a bathtub or sink. Avoid using harsh chemicals or abrasive materials, as these can damage the surface of the mousepad.

Step 2: Mix the soap with some lukewarm water. You don't need a lot of soap – a few drops should be enough. Stir the mixture until the soap is fully dissolved. Dip your cloth or sponge into the soapy water and squeeze out any excess. You want the cloth to be damp, not soaking wet.

Step 3: Gently wipe down the surface of the mousepad with your damp cloth or sponge. Be sure to get into all the nooks and crannies, as dirt and grime can accumulate in these areas. Scrub until you no longer see any dirt or stains.

Step 4: Rinse and dry. Once you've cleaned the surface of the mousepad, rinse it off with clean water and pat it dry with a towel. Avoid wringing or twisting the mousepad, as this can damage the material. Let it air dry for 24-48 hours: Once the mousepad is dry, make sure to place it on a flat surface to allow it to air dry completely before using it again. This will help prevent any remaining moisture from damaging the surface of the mousepad or warping.

With just a few simple steps, you can keep your water-resistant mousepad looking clean and new! Just be sure to use a mild soap and a soft cloth or sponge to avoid damaging the surface.

Need an upgrade?